Table of Contents
Advertisement
Instructions for the user
6.
6.1 Lighting the burners
Before lighting the hob burners check that the flame caps are in the
correct position and that their burner caps are in place, making sure that
the holes A in the flame caps correspond to the spark plugs and
thermocouples.
The optional grid B is for use with "woks" (Chinese pans).
To prevent damage to the worktop, the hob is equipped with a raised
grid C: installs over pans larger than the diameter shown in the table in
paragraph " 6.3 Diameter of receptacles". Note that pans larger than 30
cm diameter must be used only on the central burner.
Each knob corresponds to the burner indicated. The
appliance is equipped with an electric lighting device.
To light the burners, press and turn the knob
anticlockwise to the large flame symbol
knob pressed for about 2 seconds to let the
thermocouple heat up.
If the burner turns off when the knob is released, it means that the
thermocouple isn't hot enough. Repeat ignition and keep the knob
pressed longer.
Once the burner has been ignited, the flame can be regulated as
required.
Always check that the control knobs are in the position
finish using the hob.
If the burners turn off accidentally, a safety device will trip after about 20
seconds to cut off gas flow (even with the gas tap open).
14
USE OF THE COOKING HOB
. Keep the
(off) when you
Advertisement
Table of Contents
