Smeg PLA68XU Instruction Manual page 18

USER INSTRUCTIONS
FAULT
E7
E8
E9
Light off
If an alarm situation occurs, the dishwasher interrupts the current program and
signals the fault.
• Alarms E1, E2, E3, E4, E8, E9 immediately terminate the current program.
• Alarms E5, E6 interrupt the current program and, after the problem has been
eliminated, resume the cycle.
• Alarm E7 is displayed at the end of the cycle which, however, is completed
given that it does not jeopardize dishwasher operation.
To "reset" an alarm:
• open or close the door, or switch the appliance on and back off again. At this
point, the dishwasher can be programmed again.
If the fault persists, contact the Authorized Technical Assistance Ser-
vice.
Rev 0.0
Turbine fl ow-regulator malfunction
The appliance is unable to precisely measure the
quantity of incoming water. Interrupt the current
program and switch off the dishwasher. Switch it
back on again, program a new cycle and press
start. If the problem persists, contact the technical
assistance service.
Alternate washing system malfunction
Interrupt the current program and switch off the
dishwasher. Switch it back on again, program a
new cycle and press start. If the problem persists,
contact the technical assistance service.
Water intake system malfunction
Contact the technical assistance service.
Light on
DESCRIPTION
Tab. 4-01b
Light fl ashing
EN
17