Troubleshooting - Smeg PLA68XU Instruction Manual

EN
5

TROUBLESHOOTING

The dishwasher can signal a number of malfunctions by turning on various
indicator lights, as described below (see following table):
E1
E2
E3
E4
E5
E6
16
USER INSTRUCTIONS
FAULT DESCRIPTION
Acquastop failure
The anti-fl ooding system has tripped. Activates
in case of water leaks. Contact the technical
assistance service.
Safety level
The system limiting the water level in the dishwasher
has tripped. Interrupt the current program and
switch off the dishwasher. Switch it back on again,
program a new cycle and press start. If the problem
persists, contact the technical assistance service.
Water heating malfunction
The water is not heated or is incorrectly heated.
Repeat the washing program; if the problem
persists, contact the technical assistance service.
Water temperature monitoring malfunction
Interrupt the current program and switch off the
dishwasher. Switch it back on again, program a
new cycle and press start. If the problem persists,
contact the technical assistance service.
Water intake malfunction
The appliance does not take in water or does so
incorrectly. Make sure the water connections are
correct, that the water supply tap is open and that
the fi lter is not clogged. If the problem persists,
contact the technical assistance service.
Water pump-out malfunction
The appliance does not pump out the water or
does so incorrectly. Make sure the drain hose is not
kinked or crushed and that the siphon and fi lters
are not clogged. If the problem persists, contact
the technical assistance service.
Tab. 4-01a
Rev 0.0