Smeg PLA68XU Instruction Manual page 12

USER INSTRUCTIONS
To cancel or change the delay of a program once it has begun:
• press the start/pause button (ref. 2 fi g. 2-02) for a few seconds until the
program delay indicator light (ref. 6 fi g. 2-02) and the set program indicator
light (ref. 4 fi g. 2-02) stop fl ashing and remain lit; press the delay program
button (ref. 6 fi g. 2-02) to modify or cancel the set delay (indicator lights 3,
5, 8 fi g. 2-02 off);
• press the start/pause button (ref. 2 fi g. 2-02) to start the program. If a
delay is set, the program delay indicator light (ref. 7 fi g. 2-02) and the set
program indicator light (ref. 4 fi g. 2-02) begin fl ashing; if the program delay
is cancelled, only the program indicator light (ref. 4 fi g. 2-02) fl ashes to show
that it has started.
To enter the delay when the program has already begun, proceed as
follows.
If the program to run is the same as the current one:
• press start/pause (ref. 2 fi g. 2-02) and hold it down for a few seconds until
the indicator lights of programs four and fi ve (ref. pr. 4, pr. 5 fi g. 2-03, marked
"end") light up;
• cancel the current program (see section 2.2.6 "Canceling the current pro-
gram") and wait for the cycle to fi nish;
• select the program once again;
• select the required delay;
• press the start/pause button (ref. 2 fi g. 2-02) to start the program.
If the program to run is different from the current one:
• press start/pause (ref. 2 fi g. 2-02) and hold it down for a few seconds until
the indicator lights of programs four and fi ve (ref. pr. 4, pr. 5 fi g. 2-03, marked
"end") light up;
• change program;
• select the required delay;
• press the start/pause button (ref. 2 fi g. 2-02) to start the program. The
dishwasher will drain and continue with the required delay and the new pro-
gram.
Rev 0.0
EN
11