Cintel Audio And Keykode Reader Upgrade - Blackmagicdesign Cintel Installation And Operation Manual

Cintel Audio and Keykode Reader Upgrade

To accommodate the newer magnetic head for the Cintel Audio and KeyKode Reader,
a replacement of the audio arm sub assembly is required. After replacing the arm sub assembly,
the reader should be calibrated.
NOTE There are two versions of the Cintel Scanner Magnetic Head:
Magnetic Head Version 1: This version of the magnetic head is no longer available and
is installed in older Audio and KeyKode Readers with a serial number prior to 6943522.
Magnetic Head Version 2: This is the current version of the magnetic head installed in
Audio and KeyKode Readers with the serial number 6943522 and onwards.
If you already have a version 2 magnetic head installed in your Audio and KeyKode
Reader, you can follow the procedure in the 'Audio and KeyKode Reader Magnetic
Head Replacement' section of the main Cintel manual to replace your magnetic head.
If you have a version 1 magnetic head installed, follow the procedure in this manual to
upgrade to a version 2 model. This upgrade process is complex, requires extra parts
and should only be attempted if you have the proper audio engineering experience as
it is easy to misalign the magnetic head. Alternatively, our sales office can perform the
upgrade. For more information go to www.blackmagicdesign.com/support.
Tools required
The following list of tools are required:
T10 driver.
HEX 1.5 x 60 driver.
PH 00 driver.
HEX 2.5 mm driver.
Small tweezers or pliers.
Cintel Audio and Keykode Reader Upgrade 4