Jump-Starting - BMW F 900 R 2019 Rider's Manual

Replacing LED for side
light
The LED side light can be
replaced only as a complete
unit. Consult a specialist work-
shop, preferably an authorised
BMW Motorrad retailer.
Replacing LEDs for brake
light and tail light
The LED rear light can be
replaced only as a complete
unit. Consult a specialist work-
shop, preferably an authorised
BMW Motorrad retailer.
Replacing bulbs for front
and rear turn indicators
LED turn indicators can be
replaced only as a complete
unit. Consult a specialist work-
shop, preferably an authorised
BMW Motorrad retailer.

Jump-starting

ATTENTION
Excessive current flowing
when the motorcycle is
jump-started
Wiring smoulders/ignites or dam-
age to the on-board electronics
If the motorcycle has to be
jump-started connect the leads
to the battery terminals; never
attempt to jump-start the en-
gine by connecting leads to the
on-board socket.
ATTENTION
Contact between crocodile
clips of jump leads and
vehicle
Risk of short-circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
greater than 12 V
Damage to the on-board elec-
tronics
Make sure that the battery of
the donor vehicle has a voltage
rating of 12 V.
Remove the seat (
When jump-starting the engine,
do not disconnect the battery
from the on-board electrical
system.
9
177
92).
z