Node Rear View - Lenovo ThinkSystem SD535 V3 System Configuration Manual

Node rear view

The following illustrations show the controls and connectors on the rear of the ThinkSystem SD535 V3 node.
Depending on the specific configuration, some of the components or connectors might not be supported.
Figure 4. Rear view
Table 6. Components on the rear view
PCIe slot 1
1
OCP slot
2
Mini DisplayPort connector
3
1 PCIe slots
Install PCIe adapters to the riser.
Table 7. PCIe slots
PCIe slot 1
1
2 OCP slot
The system may support a 2-port or a 4-port OCP module for network connections. Port numbering are
shown in the illustrations below.
Figure 5. Port numbering — 2-port OCP module
Figure 6. Port numbering — 4-port OCP 3.0 module
3 Mini DisplayPort connector
Connect a Mini DisplayPort-compatible video device, such as a monitor, to this connector.
Note: The maximum video resolution is 1920 x 1200 at 60 Hz.
ThinkSystem SD535 V3 System Configuration Guide
22
USB 2.0 connector with Lenovo XClarity Controller
4
(XCC) management
USB 3.2 Gen 1 (5 Gbps) connector
5
XCC system management port (10/100/1000 Mbps RJ-
6
45)
PCI Express 5.0 x16, HH/HL, 75-watt