Table of Contents
Advertisement
4
USB 2.0 connector with Lenovo XClarity Controller (XCC) management
Note: This is the only USB port that supports USB automation update of the firmware and RoT security
module.
Connection to Lenovo XClarity Controller is primarily intended for users with a mobile device running the
Lenovo XClarity Controller mobile application. When a mobile device is connected to this USB port, an
Ethernet over USB connection is established between the mobile application running on the device and the
Lenovo XClarity Controller.
Select Network in BMC Configuration to view or modify settings.
Four types of settings are available:
• Host only mode
In this mode, the USB port is always solely connected to the server.
• BMC only mode
In this mode, the USB port is always solely connected to Lenovo XClarity Controller.
• Shared mode: owned by BMC
In this mode, connection to the USB port is shared by the server and Lenovo XClarity Controller, while the
port is switched to Lenovo XClarity Controller.
• Shared mode: owned by host
In this mode, connection to the USB port is shared by the server and Lenovo XClarity Controller, while the
port is switched to the server.
5
USB 3.2 Gen 1 (5 Gbps) connector
Connect a USB device, such as a mouse, keyboard, or other devices, to this connector.
6
XCC system management port (10/100/1000 Mbps RJ-45)
The node has a 10/100/1000 Mbps RJ-45 connector dedicated to Lenovo XClarity Controller, which cannot
be accessed directly from the production network. A dedicated management network provides additional
security by physically separating the management network traffic from the production network. You can use
the Setup Utility to configure the node to use a dedicated systems-management network or a shared
network.
See the following for more information:
•
"Set the network connection for the Lenovo XClarity Controller" on page 49
•
"XCC system management port LEDs" on page 32
Top view
This following illustration provides information on the top view of the ThinkSystem SD535 V3 node.
Note: Depending on the specific configuration, the hardware might look slightly different from the
illustrations in this section.
.
Chapter 2
Hardware components
23
Advertisement
Table of Contents
