Speaker; Removing The Right-Speaker - Dell Latitude 9450 2-in-1 Owner's Manual

NOTE: The power button with fingerprint reader connects to the USH board and the USH-board FPC cable connects to
the system board. The power button without fingerprint-reader FPC connects directly to system board and it uses the
same connector as the USH-board FPC connector on the system board.
4. Place the power-button bracket on the power-button assembly.
5. Replace the single (M1.6x2) screw to secure the power-button bracket to the palm-rest assembly.
Next steps
1. Install the system board.
2. Install the battery.
3. Install the heat sink.
4. Install the display assembly.
5. Install the left fan.
6. Install the right fan.
7. Install the WWAN card, if applicable.
8. Install the solid-state
9. Install the base cover.
10. Install the Nano-SIM card tray
11. Follow the procedure in

Speaker

Removing the right-speaker

CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE: Ensure that your computer is in Service Mode. For more information, see step 6 in
computer.
2. Remove the nanoSIM-card
3. Remove the base cover.
4. Remove the WWAN card, if applicable.
5. Remove the battery.
About this task
NOTE: For systems that are shipped with WWAN antennas, the right-speaker is integrated with the palm-rest assembly
and it is not a separate replaceable part.
NOTE: For systems shipped with the WLAN card, the right speaker is a separate replaceable part. The following procedure
is applicable only for systems that shipped with the WLAN card.
The following images indicate the location of the speaker and provide a visual representation of the removal procedure.
drive.
if applicable.
after working inside your
before working inside your
tray.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
before working inside your
81