Installing the solid state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid state drive and provides a visual representation of the installation
procedure.
Figure 30. Installing the solid state drive
Steps
1. Align the notch on the solid state drive with the tab on the solid state drive slot.
2. Slide the solid state drive at an angle into the solid state drive slot on the system board.
3. Align and place the solid state drive shielding cover, press to fit it firmly in place to cover the solid state drive.
4. Tighten the captive screw to secure the solid state drive to the system board.
Next steps
1.
2. Install the
base
cover.
3. Install the
Nano-SIM card
4. Follow the procedure in
Wireless Wide Area Network (WWAN) card
Removing the WWAN card
Prerequisites
1. Follow the procedure in
tray.
after working inside your
before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
51