Use Of The Hob; Lighting Of The Hob Burners - John Lewis JLRCBK105 Instruction Manual

Use of the hob

Caution! Before lighting the hob
burners check that the flame caps
are in the correct position and
that their burner caps are in place,
making sure that the holes A in
the flame caps correspond to the
spark plugs and thermocouples.
This optional grid is for use with "woks"
(Chinese pans).
To prevent deterioration of the hob the
appliance is equipped with a raised pan stand
to be placed underneath pans more than 26
cm in diameter. The supplied reduction rest
is used also for small pans.

Lighting of the hob burners

The drawing next to each knob shows the
corresponding burner. The appliance has an
electronic lighting device. Simply press and
turn the knob anticlockwise to the minimum
flame symbol , until the flame is lit. Hold the
knob down for a few seconds to allow the
thermocouples to heat up. The burner may
go out when the knob is released: this is
because the thermocouple has not been
sufficiently heated. Repeat the operation
holding down the knob a little longer. This
operation is not necessary for burners
without thermocouples.
16