Safety Instructions - Circontrol Wallbox eHome Series Installation Manual

WallBox eHome Series Installation Manual
IMPORTANT SAFETY INSTRUCTIONS
Read carefully all the instructions before starting in order
to ensure properly installation of the charge point.
The charge point is designed for installation in indoor and outdoor areas. For each of
the different conditions of installation, the unit must be installed safely and ensure
adequate protection.
¢ — Charge point must not be installed
in areas where there is potential
risk of explosions.
¢ Do not install the charge point
where falling objects may damage
the equipment.
* The Charge Point can be installed
in locations with non-restricted
acces.
e The surface where the charge
point is placed must withstand the
mechanical forces.
* Do not use this unit for anything
other than electric vehicle charging
modes are expected in IEC 61851,
¢ Do not modify this unit. If modified,
CIRCONTROL will reject all
responsibility and the warranty will
be void
Comply strictly with electrical safety
regulations according to your country.
Do not make repairs or manipulations
with the unit energised.
Only trained and qualified personnel
should have access to low-voltage
electrical parts inside the unit.
Check the installation annually by
qualified technician.
Remove from service any item that has
a fault that could be dangerous for users
(broken plugs, caps that don't close...).
Use only Circontrol supplied spare
parts.
Do not use this product if the enclosure
or the EV connector is broken, cracked,
open, or shows any other indication of
damage.
Refer to TECHNICAL DATA section for more information about environmental installation conditions,