Table of Contents
Advertisement
Installing The Indoor Unit
( Ri g ht-Si
d e, Ri g ht-Back or Ri g ht-Bottom Pi p i n g
1)
Open the front panel, open the Front grille (If Required), then open the service
lid.(Refer to Installation Tips.)
2)
Shape the refrigerant pipes.
3 )
Pass the drain hose and refrigerant pipes through the wall hole.
4)
Hang the indoor unit on (A) mounting Plate
5 )
Pass the inter-unit wires from the outdoor unit through the feed-through wall hole
and then through the back of the indoor unit. Pull them through the front side. Bend
the ends of tie wires upward in advance for easier work. (If the inter unit wires ends
are to be stripped first, bundle wire ends with adhesive tape.)
6)
Connect the refrigerant pipes.
7 )
Bind refrigerant pipe and drain hose with vin}1 tape then wrap the
refrigerant pipes and drain hose together with insulation tape (field supply) as
shown in the figure.
8)
Hook the claws of the bottom frame to the mounting plate, press the bottom frame of
the indoor unit with both hands to set it on the (A) mounting plate hooks. Make sure
the wire lead do not catch on the edge of the indoor unit.
9 )
Secure the indoor unit to the (A) mounting plate with the (E) indoor unit fixing screws
(M4 x12L).
10) Caulk the gap between the pipe and the front grille with putty.
11) After completing refrigerant piping, wiring and drain piping, caulk pipe hole gap
with putty.
( Left-Si d e, Left-Back, or Left-Bottom Pi p i n g
For left piping addition things need to be taken care.
1)
Be sure to connect the drain hose to the drain port in place of a drain plug.
2)
Install the unit as per mentioned above RHS side.
e l _ l _ E m _b e _ d _ d _ e _ d _ P _ i p _ i n _ g __ )
..... ( W_
1) Insert the drain hose to this depth so it won't be pulled out of the drain pipe
Indoor Unit
)
)
�
...
-· ·
@Modng
Hang Indoor
unit's hook here.
Mounting
When stripping lhe
plate
ends of Inter-unit
wires in advance,
bind right ends ol
wires with
insulating tape.
@Mounti n g
plate
ns
V i n y l ta p e
hoH Cau l k 1n l s hale
::�
�:� t ':: on
(I n side l n sulatmg tape) of refrigerant p i p e.
wit h puffy or
ce u l k kll mat«1al
Over l ap at least half the
wl d thofthetapewl t h
eacnt1.1 m .
@Mounting plate --½-
�
Front
grille
How to set drain plug
Do not apply lubntatlng oil
(ndl'igwant oil) to the drain
plug when Inserting It
lhe applcatlon r1 lubflcatlon
oil to the drain plug will
#
deteriorate the plug to cauH
drain lea�• from thaplug.
nsert a hexagon wrench (4mm)
6
Advertisement
Table of Contents
