Daikin F Operation Manual page 12

■
Operation
LED / 7 SEGMENT BRIGHTNESS Control Operation
The brightness of the indicator lamp/ 7 Segment can be adjusted H(high), L(low), or OFF.
To set the brightness setting mode.
Press [<:•swiNG J for more than 5 second's.
• L d
is displayed on the LCD.
EJ
■
Press will show the last memory setting of brightness intensity of indicator lamp/ 7 Segment.
8
■
Again Press to adjust the brightness to the Indicator lamp / 7 Segment.
Ld
I
H(Hi g h)
■
Press [<:• swiN G jfor about or more than 5 second's again to exit from the brightness setting mode or when the
remote controller Is left untouched for 60 second's, It returns to the normal mode automatically.
DEW CLEAN Operation
This Function helps to clean accumulation of Dust & Stain on indoor Heat Exchanger.
■
To use DEW CLEAN operation, Remote Controller and Machine should be in ON operation and follow the
below steps.
�
■
Press DEW CLEAN for more than 2 second's and release the button then
times and then it disappears.
■
The LED indicator lamp (green and orange) on the Indoor Unit will blink together during the operation.
■
The operation stops automatically as per below defined process and unit will switched OFF after completion.
Once press
Dew Clean
Dew Cleaning mode
button
To cancel DEW CLEAN operation
-Turn OFF the machine from Remote Controller /Wi-Fi Control
NOTE
■
Note on LED / 7 Segment Brightness Control :
• "Ld" indicates for the brightness )Light) feature which is appeared on set temperature area.
• Remote will be in High Brightness Intensity by default whenever batteries inserted.
• Keep this in mind that If user sets LED lights to be in "OFP' state )using Brightness control feature) and if Power failure
occurs then when power will resume LED will remain in OFF state )needs to reset LED Brightness Control again)
■
Note on DEW CLEAN operation :
• During DEW CLEAN operation, except Streamer other functions of Remote will not work.
• Automatically controls temperature and airflow rate, so manual adjustment of these function is unavailable.
• If Mains Power Reset or Power failure occur, Dew Clean Operation will stop.
• User is recommended to avoid staying inside the room during Dew Clean operation as Indoor temperature will be lower.
• If room temperature is lower than minimum remote temperature setting then this function will not work.
• Recommended temperature range to operate this function is more than 24
• Recommended to use this function once in a month to get better cooling effect.
• Do not keep LED lights in " OFP state (using Brightness control feature) before starting Dew Clean Operation, otherwise
light will not blink during the operation making it difficult to identify the Dew Clean mode.
• This function is available in both COOL and DRY Mode of operation.
11
- 1
1 ------rd
��
L(Low)
· �
□
About 65 minutes
-
-
(Cooling operation}
'1dl
+­
OFF
' e "
blinks on the remote LCD 4
About 30 minutes
End
(Unit will
Dry mode
OFF}
° C.
Appprox. 95 minutes
{l hours 35 minutes}