3.
Disconnect the cable from the reverse ZIF connector (4) on the camera module.
To install the second camera module, reverse this procedure.
Pen charger
To remove the pen charger, use these procedures and illustrations.
Table 5-8
Pen charger description and part number
Description
Pen charger (in the Cable Kit)
Before removing the pen charger, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the pen charger:
1.
Lift the tape (1) off the pen charger system board connector. The tape can remain attached to the
system board.
2.
Disconnect the cable (2) from the system board ZIF connector.
3.
Remove the three Phillips M1.6 × 4.0 screws (3) from the charger.
38
Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
28).
Spare part number
N85027-001
28).
Battery on page
29).