Table of Contents
Advertisement
6.
Lift inside of the board up, and then pull the board (2) into the computer to remove it.
To install the USB board, reverse this procedure.
Second camera module
To remove the second camera module, use these procedures and illustrations.
Table 5-7
Second camera module description and part number
Description
Second camera module
Before removing the second camera module, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the second camera module:
1.
Remove the two Phillips M2.0 × 3.0 screws (1) from the bracket over the module, and then remove
the bracket (2).
2.
Lift up the module (3) so you can access the connector underneath.
(Preparation for disassembly on page
Bottom cover on page
Battery on page
29).
28).
Second camera module
Spare part number
N91928-001
28).
37
Advertisement
Table of Contents
