Pride JAZZY1107 Owner's Manual page 39

V I I .
To replace the batteries:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode. See III.
"Your Power Chair."
3. Remove the battery boxes. See IV. "Assembly/Disas-
sembly."
4. Disconnect the wiring harness from the batteries.
5. Remove the batteries from the battery boxes.
6. Place new batteries in the battery boxes. See figure 28.
7. Reconnect the battery harnesses according to the bat-
tery wiring diagram label. See figure 29.
WARNING! Make sure you tighten the
fasteners so that the connections are secure.
8. Reinstall the battery boxes onto the power base. Make
sure that the battery box latches are in the up (locked)
position.
9. Charge the batteries. See VI. "Batteries and Charging."
When to See Your Authorised Pride Dealer for
Service
The following symptoms could indicate a serious problem with
your power chair. If necessary, contact your authorised Pride
Dealer. When calling, have the model number, serial number,
nature of the problem and the error code if available.
! Motor noise
! Frayed harnesses
! Cracked or broken connectors
! Uneven wear on any of the tyres
! Jerky motion
! Pulling to one side
! Bent or broken wheel assemblies
! Does not power up
! Powers up, but does not move
Corrective Maintenance
If the battery condition meter does not light up when you turn
on the power:
! Check the harness connections. Make sure they are tight.
! Check the circuit breaker. Reset it if necessary.
! Check the battery connections.
If the above conditions prove normal, you can load test the batteries with a battery load tester. These testers are available
at automotive parts stores. Disconnect both batteries before load testing and follow the directions that come with the load
tester. If either one of the batteries fails the load test, replace both of them. If your power chair still does not power up,
contact your authorised Pride Dealer.
Jazzy 1107
C A R E A N D
www.pridemobility.com
M A I N T E N A N C E
REAR BOX
Figure 28. Battery Boxes
Figure 29. Battery Wiring Diagram
MAIN CIRCUIT BREAKER
FRONT BOX
39