Pride JAZZY1107 Owner's Manual page 22

I V . A S S E M B L Y / D I S A S S E M B L Y
Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair. Most seats
are attached to the power base with the Universal Mounting
System (UMS). The UMS consists of universal parts that
may be attached to any medium-back or high-back seat,
regardless of seat width or seat depth. The two main
components are aluminum extrusions mounted to the seat
base. These extrusions attach to a set of trapeze bars that
are mounted to the power base (see figure 12).
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat (initial installation):
1. Prior to initial installation, the rear seat interface needs
to be installed to the seat base.
2. Slide the rear seat interface into the rear extrusion. See
figure 11.
3. Squeeze the retaining pin and clip it onto the rear
seat interface.
4. Slide the seat onto the side trapeze bars and slowly
lower the seat onto the front trapeze bar until it locks
into place. See figure 12.
5. Flip the seat latch safety down. See figure 12.
WARNING! Make sure the seat latch
safety is flipped down before using your
power chair.
6. Install the controller into one of the armrests. See
figure 10.
7. Tighten the setscrew on the armrest. See figure 19.
8. Route the controller cable so that it cannot be pinched
in the seat hinge.
9. Secure the controller cable to the armrest receiver with
one or more wire ties.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller
harness on the outside of the armrest
pad. Route the har ness under the
armrest or toward the inside of the
ar mrest pad. Use cor rect tie-down
points for the controller harness to
prevent the harness from getting caught
in the drive tyres, pinched in the seat
frame or damaged when passing
through doorways.
22
REAR SEAT INTERFACE
RETAINING PIN
Figure 11. Assembly View (Rear Seat Interface Installation)
SIDE
TRAPEZE
BARS
Figure 12. Seat Installation
www.pridemobility.com
REAR EXTRUSION
FRONT EXTRUSION
SEAT LATCH
SAFETY
SEAT LATCH
FRONT TRAPEZE
BAR
Jazzy 1107