Pride JAZZY1107 Owner's Manual page 26

V . C O M F O R T
Seat Position Adjustment
You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Unplug the controller from the power base.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat. See
figure 17.
5. Reposition the extrusions on a different set of mounting
holes. You must move both extrusions the same number
of holes either forward or rearward. See figure 17.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Plug the controller into the power base.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you can
adjust the seatback angle with the seatback release lever. The
lever is located on the right side of the seat base. See figure 5.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or rearward to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback,
you can adjust it to four (4) different angles: 90°, 102°, 105°
or 107°.
To adjust the seatback angle:
1. Remove the seatback angle adjusting screw from each
seat hinge. See figure 18.
2. Set the seatback at the desired angle.
3. Reinstall the seatback angle adjusting screw to each seat
hinge and tighten.
26
A D J U S T M E N T S
Figure 17. Seat Position Adjustment
LOCKING
NUT
ARMREST
ANGLE
ADJUSTING
SCREW
ARMREST HEIGHT
ADJUSTING
SETSCREWS
SEATBACK
ANGLE
ADJUSTING
SCREW
ARMREST KNOB
Figure 18. Seatback Angle Adjustment
www.pridemobility.com Jazzy 1107