6.14 Service setting (for After‐Sales Service only)
6.15 Starting the peristaltic pumps – rapid filling of detergent and rinse aid
delivery circuit.
Perform after the parameter modification procedure explained in the previous point.
Indicator lights showing: off; green; orange;
With the dishwasher powered up, access "programming
mode" by pressing the on/off button for a few seconds; at
the "beep", release the button and press it again quickly
within 0.5 seconds.
The peristaltic pumps continue to operate until the same
button is pressed again. The rinse aid and detergent symbol
lights remain on as long as the pumps are on; bear in mind
that the rinse aid peristaltic pump fills the circuit in about 7
minutes, while for the detergent it only takes 2 minutes.
‐ CW 521/531
See information on Smegtech
flashing.
22