Table of Contents
Advertisement
M.2 solid-state drive
Follow the instructions to replace the M.2 solid-state drive.
Before you start, read
Generic Safety and Compliance Notices
Attention: The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise, the M.2 solid-state
drive might get damaged.
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive
on a soft material, such as cloth, to absorb physical shocks.
For access, remove these FRUs in order:
• "LCD module" on page 56
• "Thermal fan assembly" on page 71
Step 1.
Note: A tape might cover the thermal pad. Without disconnecting volume board cable, peel off the
tape carefully to access the thermal pad and the solid-state drive.
Loosen the screw and then remove the thermal pad and the solid-state drive.
and print the following instructions.
.
Chapter 8
Removing or replacing a FRU
73
Advertisement
Table of Contents
