Step
Screw (quantity)
2
M2 × L2 mm, flat-head, nylon-coated (1)
Step 2.
Install the Wireless WAN card in reverse order. When installing, ensure that you connect the red
cable to the main connector, and the blue cable to the auxiliary connector.
Power board and cable
Follow the instructions to replace the power board and cable.
For access, remove these FRUs in order:
• "LCD module" on page 56
• "Thermal fan assembly" on page 71
Step 1.
Remove the power board and cable as shown below.
a.
Release P sensor cable. Disconnect the connector. Loosen the screw and then remove the
power board and cable.
76
ThinkPad X12 Detachable Gen 2 Hardware Maintenance Manual
Color
Torque
0.181 Nm
Silver
(1.85 kgf-cm)