Remove The Solid-State Drive (Ssd) - Lenovo 82R700JNIX Hardware Maintenance Manual

Remove the solid-state drive (SSD)

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 35
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw. Remove the SSD and SSD bracket by pulling it away from the slot.
Figure 8. Remove the SSD and SSD bracket
Screw specifications
M3.5 x L0.4
Step 3. Remove one screw then remove the SSD bracket.
Figure 9. Remove the SSD bracket
Screw specifications
Step 4. Remove the SSD thermal pad.
Number of screws
1
Number of screws
1
.
Chapter 4 Removing a FRU or CRU
37