Identification - Grizzly G0458ZX Owner's Manual

Become familiar with the names and locations of the controls and features shown below to better under-
stand the instructions in this manual.
A
B
C
D
A. Circuit Breaker Reset Button: Allows
machine to be restarted after thermal over-
load protection has tripped. To reset, place
ON/OFF switch in OFF position, wait a few
minutes for motor to cool, then press reset
button. If button does not stay depressed,
allow motor to cool longer, then try again.
B. ON/OFF Paddle
Removable Key: Turns motor ON and OFF.
Remove yellow key to disable switch.
C. Conveyor Feed Rate Dial: Rotate dial coun-
terclockwise to decrease conveyor belt feed
rate or clockwise to increase feed rate.
Conveyor feed rate ranges from 0–12 FPM.
D. Table Height Indicator: Displays approxi-
mate distance between sanding drum and
conveyor belt.
Model G0458ZX (Mfd. Since 04/24)

Identification

E
F
Safety Switch w/
To reduce your risk of
serious injury, read this
entire
using machine.
G
E. Dust Port: Connects sander to 4" dust col-
lection system.
Table Elevation Handwheel: Raises and
F.
lowers conveyor table (G). Rotate counter-
clockwise to lower table; rotate clockwise to
raise table. One full rotation moves the table
approximately 0.060" (
G. Conveyor Table w/Belt: Feeds workpiece
during sanding operations.
H. Belt Access Panel: Remove panel to change
sanding drum pulley positions or make belt
adjustments.
Conveyor Belt Motor: Drives conveyor belt.
I.
Use Conveyor Feed Rate Dial (C) to adjust
feed rate.
manual BEFORE
H
I
⁄ ").
1
16
-3-