NEEDLE HEIGHT
The height of the needle should be set
so that the tip of the hook lies in the
groove of the needle for both right and
left-hand penetration.
Correction or resetting is performed as follows:
Set zig-zag width to maximum (4.5 mm) and penetrate needle in left-hand stitch. When
the loop lift is completed the lower edge of the hook tip should lie approx. 0.2-0.3 mm
over the upper edge of the eye of the needle.
Adjustment of the needle bar can be made after loosening the hexagonal screw 1 1 5 on
the needle bar carrier 1 14.
When moving the needle bar it should be ensured that it is not twisted when the screw
1 1 5 is re-tightened. Check with a DUO-needle (3 or 4 mm distance).