Table of Contents
Advertisement
Loosen the two screws on worm wheel 73. Then using the screwdriver secure the worm
wheel 73 now loose on the spindle, while pressing the setting ring 7 4 and turning the
handwheel at the same time, until the correct setting is found. Tighten both screws on
worm wheel 73.
-
_
_ ,
---
.
4 -
1
BASIC SETTING OF THE TRACER LIFTER STRAP
To ensure that the notched carrier has sufficient range of adjustment, the lifter strap 8 0
must be set to the correct position.
The following procedure should be adopted:
1. Release two fixing screws 8 1 and 82.
2. Insert distance gauge at front between cam control lever and lifting rail 8 0 and press
the lifter strap slightly against the distance gauge (1.2 mm).
3. Tighten screw 8 1 slightly.
4. Repeat operations 2
+
3 on other side (back).
5. Tighten both screws 81 and 82.
Advertisement
Table of Contents
