Figure 11. Remove the SSD thermal pad
Go to
https://support.lenovo.com/partslookup
replacement parts:
2242 solid-state drive
SSD thermal pad
Remove the heat sink
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 27
Step 1.
Disconnect the battery pack cable from the system board, remove three screws, and remove the
heat sink.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 12. Disconnect the battery pack cable, remove three screws, and remove the heat sink
Screw specifications
M1.6 × L1.7
to look up the Lenovo part numbers of the following
Number of screws
3
Torque
1.4 ± 0.1 kgf-cm
.
Chapter 4
Removing a FRU or CRU
33