Table of Contents
Advertisement
■ Supplying Power with the Battery
The Battery was only minimally charged before shipping.
Therefore, fully charge it before you use it for the first
time.
1 Place the Battery on the AC Adaptor as
shown above and slide It horizontally
until It stops.
2 Connect the AC Mains Cable to the AC
Adaptor and an AC mains socket.
®: Hong Kong only
3 When all four Charge Lamps on the AC
Adaptor are lit, charging is finished.
4 Remove the Battery by sliding it in the
opposite direction of Step 1 above.
•Also disconnect the AC Mains Cable.
5 Slide the [A BATTERY] Lever.
6 Open the Battery Compartment Cover.
7 Insert the Battery with Q pointing
inside.
8 Close the Battery Compartment Cover
so that it locks with a click.
Removing the Battery
Open the Battery Compartment Cover and push the
Battery Eject Lever ©.
♦ Hold your hand over the Battery Compartment Cover to
prevent the Battery from dropping.
♦ Before removing the Battery, set the [POWER
ON/OFF] Switch to [OFF].
Caution
Be sure to insert the Battery with the [A] mark pointing
into the Movie Camera, if you insert it with the mark
SJI±•
®: ttAftffSC
Hf ■
•
4
■ m
JtSHJ «
5 »» [ A BATTERY] (*») Si •
6 ttMVi&KS'
7 JSA*?fe ■
-
EfflWiSB#
JTHmteSM ■
tswmmmo
<■
♦
- bBJUHPOWER ON/OFFOTi55t£[OFF]°
«&*
'
m tmmmwm
°
Advertisement
Table of Contents
