Table of Contents
Advertisement
ENGLISH
Adding New Sound on a Recorded
Cassette
(Audio Dubbing)
To perform audio dubbing, the Remote Controller is
necessary.
You can add music or narration to a recorded cassette.
♦ If [AUDIO REC] on the [MENU (OTHERS)] Menu has
been set to [16blt], performing audio dubbing will
completely erase the previously recorded sound.
Therefore, If you intend to perform audio dubbing but
also want to keep the original sound, be sure to set
[AUDIO REC] on the [MENU (OTHERS)] Menu to
[12bit] before making the original recording.
♦ It is not possible to perform audio dubbing onto
recordings made in the LP Mode. (-*24)
1 Insert the recorded cassette and set the
[POWER ON/OFF] Switch to [ON].
2 Press the [VCR/CAMERA] Button so
that the [VCR] Lamp lights.
3 At the point where you want to insert
the sound, switch the Movie Camera
over to the Still Playback Mode.
4 Press the [A.DUB] Button on the
Remote Controller.
5 Press the Pause Button [II] on the
Remote Controller to start audio
dubbing.
TO
♦ to&CMENU (OTHERS) ]3S#±M[AUDIO REC]
H
• j$[MENU (OTHERS)]^
±ft[AUDIO REC)s£££[12{&] °
(-*24) *
1 ffiAEffii**** • tH[POWER on/offjm
IM*£S£[ON] •
2 S[VCR/CAMERA]
ffl ■ ffi[VCR]®3Se •
3
mfjnmxmwtn
■
mmmmtm
5
■ Bsjt&wasmt"
i
i
%
L
C
0
H
A
H
Stopping Audio Dubbing
Press the Pause Button [II] on the Remote Controller.
The Movie Camera is again in the Still Playback Mode.
Advertisement
Table of Contents
