Table of Contents
Advertisement
ENGLISH
Before Requesting Service
(Probiems & Solutions)
Power Supply
PI:
The Movie Camera does not turn on.
Si:
Is the Battery or the AC Adaptor connected
correctly? Confirm the connection. («♦ 16)
P2:
The Movie Camera has turned off
automatically.
S2:
If you leave the Movie Camera in the Recording
Pause Mode for more than 6 minutes, it
automatically switches off to protect the tape and
to conserve battery power. («♦ 30)
P3:
The Movie Camera quickly turns off.
S3-1: Is the Battery discharged? When the Remaining
Battery Power indication is flashing or the
II-1*3 indication is displayed, the Battery is
discharged. Charge the Battery or insert a fully
charged Battery. (-> 156)
S3-2: Has condensation formed? If the Movie Camera is
brought from a cold to warm place, condensation
may form inside. In this case, the Movie Camera
automatically switches off and not operations can
be performed except taking out the cassette. Wait
until the Condensation indication disappears
(-> 136)
Battery
PI:
The Battery discharges quickly.
SI -1: Is the Battery fully charged? Charge it until ail 4
Charge Lamps on the AC Adaptor light. (■+ 18)
SI-2: Are you using the Battery in a place where the
temperature is very low? The ambient
temperature greatly influences the Battery's
performance. Its operation time becomes shorter
in a cold place. (■+ 138)
SI -3: Has the Battery reached the end of its service
life? The service life of the Battery is limited. It
depends on the way the Battery is used, but when
the operation time even after proper charging is
too short for normal use, the service life of the
Battery has reached its end.
qi
;
m
•
(->16)
Q2:
nmmswim-
* ° (-* 30)
Q3:
.
as-i :
(-M56)
A3-2:
°
• JUMP
tmrF • ft## .
.
(-M36)
qi
:
nmeMtnm
•
am :
?
mmmm
■
o (-»t8)
A1-2:
i
mm-kmm
•
-
mmmm
(-M38)
^0
• n^#tifT7iE5i6t]
Advertisement
Table of Contents
