Calrec S2 Operator's Manual page 61

S2
.............................................................................................................................................................................................................................................
4.8 MULTITRACK
Channels & Groups settings
The signal input to the multitrack system from a Channel of Group is normally post fader
but can be set to pre fader or post The Direct Output control if a control is required.
The input Assign button from the Channel or Group is red and marked M/T. Channel 1 is
illuminated Green at boot-up unless previously set on another Channel or Group. Set it to
the Channel or Group to be routed or interrogated.
Routing to Tracks
Select ROUTE on the Tone/Talkback panel - green LED. Select the Track or Tracks to be
routed from the selected Channel or Group on the Multitrack control panel - green LEDs.
De-selection follows a similar procedure. ROUTE times out if not de-selected after 20 secs.
Track AFL
Select AFL on the Tone/Talkback panel - red LED. Select the Track or Tracks to send to
AFL on the multitrack control panel - red LEDs. De-selection follows a similar procedure.
Selection of any Track to AFL illuminates the AFL warning light on the Tone/Talkback
panel. AFL times out if not selected & PROVIDED THERE ARE NO AFL SELECTIONS
after 20 secs.
Interrogation
Forward interrogation is carried out in the ROUTE mode. That is which track or tracks are
fed from this channel or group? - by simply selecting M/T or that channel or group &
observing the green track select LEDs.
Reverse interrogation - that is which channels &/or groups are fed to this track? - is carried
out in the NORMAL mode - that is when ROUTE & AFL are NOT selected. The track button
is held momentarily and the M/T button green LEDs on the channels and/or groups
selected to that track, are momentarily illuminated.
Clear Routing
Select ROUTE on the Tone/Talkback panel. Press the CLEAR ROUTE times out to
ROUTE after 10 secs.
Reset
If there is an error the LED associated with RESET illuminates. Press RESET & the
system should restore to normal. For faults see the Manual referred to below.
Power Failure
The system will write the current settings into flash memory during the power decline and
on restoration will set the console accordingly. It may be necessary to press RESET.
Note that there is a separate comprehensive User Operational Manual for S Series
Multitrack Routing V1.1.
61