Calrec S2 Operator's Manual page 58

S2
............................................................................................................................................................................................................................................
58
4.1 GAIN & INPUT SETTINGS
Connect a source to a channel input & select as follows:-
Mono Mono Mic 1
Mono Line 1
(Mic or Line 2 - select MIC or LINE & press IP2 - yell LED)
Stereo Stereo Mic
Stereo Line
Stereo Line Stereo Line 1 - ensure IP2 is not pressed
(Stereo Line 2 - select IP2 - yell LED)
If the source is a microphone, turn up the switched GAIN control and adjust the TRIM
(if necessary) until the bargraph in the fader shows a level which should just occasionally
illuminate the yellow LED. (The balance control can be adjusted later).
The microphone can be phantom powered by pressing the button marked 48V (red LED)
and if necessary, phase reversed.
A line source would probably not need a switched gain away from the 0dB position although
a restricted range is available. Adjust the TRIM if necessary for the level described above.
An M/S microphone in a stereo input can be converted back to Left-Right by pressing
M/S (red LED).
Mono inputs to a stereo channel can be sent down both stereo legs by use of LB (Left
to Both), RB (Right to Both) when the balance control is inoperative or LB+RB when the
balance control pans across both inputs (for two mono feeds) and feeds both outputs with
the same panned signal.
Press the channel PFL button and the source should be heard in the PFL loudspeaker,
in stereo if so connected.
4.2 ROUTING
Select one of the eight stereo Groups or one of the two Main stereo outputs on the channel
output selectors. If a group is selected, then select that Group to a Main Output.
4.3 FADER
Fade up the channel, the group (if selected) and the selected Main to about 0dB on the
faders. It should now be possible to hear the source on the main loudspeakers by pressing
the channel, (& Group if selected), AFL button. The input balance control can be adjusted
if necessary on a stereo source in this condition.
- ensure LINE & IP2 are not pressed (red LED)
- select LINE (green LED) and ensure IP2 is not pressed
- ensure LINE is not pressed (red LED)
- select LINE (green LED)