1-Point Orientation - Leica TPS 1000 Series Manual

1-point orientation

CO
IN
ID
PM
FS
SC
OC
IO
AR
RC
EG
CA
CT
BC
DF
SD
TS
IX
88
All of the entries relevant to a new instrument
configuration are summarized in this function and can
be dealt with very quickly.
Activate the function in the dialog "START-UP
DISPLAY" (page 82).
SETUP\ 1-PT. ORIENTATION
Station :
Backsight :
Inst.Height:
Refl.Height:
Hz-Dist. :
ALL DIST
HELP
F1
F2
Enter the numbers of the station point and of the
backsight point respectively. The appropriate point is
immediately searched for in the data file and, if the
search is successful, the coordinates will be assigned to
the station point and backsight point without this fact
being displayed.
After the instrument height and the reflector height
have been entered, target the backsight point and
measure the distance and/or the direction.
Measure the distance and determine the direction, and
store the measurement block. The graduated circle is
orientated. The difference between the calculated
distance and the measured distance to the backsight
point is displayed.
Measure the distance. The difference between the
calculated distance and the measured distance to the
backsight point is displayed.
TPS-System 1000-2.3.1en
14:03
1.500 m
1.000 m
----- m
REC INPUT
I<>II VIEW
F4
F3
1
A
ñ
NUM
F5 F6
© Leica