Advertisement
өтер?
ARM PRESS ASSEMBLY
40
56" FLAT WASHER
41 S16" NYLON
LOCK NUT
43 5/16°Х2
14° HEX HEAD BOLT
€2 14"X3/4"
ROUND HEAD MACHINE SCREW
63 14"X1"
TAPER HEAD SCREW
68 41/2" X 6" HEX HEAD BOLT
72 1"ROUND PLASTIC COVER САР
74 134"SQUARE
PLASTIC INSERT CAP
T5 1"ROUND PLASTIC INSERTCAP
'
78 1° SPRING RETAINER RING
[0 Cap each end of the bottom cross-member
tube of the ARM PRESS PIVOT FRAME
(16) with 1 3/4" SQUARE
PLASTIC
INSERT
CAPS (74).
C Cap the top of the Welded.
Pivot Tubes іп
the bottom cross-member
ђе of the ARM
PRESS
PIVOT
FRAME
(16) with 1"
ROUND PLASTIC INSERT CAPS (75).
C] Assemble a 112" 10. X 2 58" LONG
METAL BUSHING (85) onto a 1/2" X 8"
HEX HEAD BOLT (68) and insert
into the
hole behind the L-Shaped
Welded Plate on
the top of the MAIN UPRIGHT (10).
Assemble
another 112" LD. X 2 5/8" LONG
METAL BUSHING (85) onto the Bolt and
secure with a 1/2" NYLON NUT (67).
п Fit a 4" LONG HALF ROUND PLASTIC PIVOT BUSHING (20) onto the ARM PRESS PIVOT FRAME (16). Assemble this
around the round tube welded between the Ат Press Pivot Frame. Position а second PIVOT BUSHING (20) arouhd the
tube.
:
п Assemble the ARM PRESS PIVOT FRAME (16) over the fop end of the MAIN UPRIGHT (10) and onto the L-Shaped Welded
Plate. Make sure that the Welded Bracket located at the bottom of the Arm Press Pivot Frame is to the front of the unit.
(О Расе
the ARM PRESS CAP (19) оп top of the ARM PRESS PIVOT BUSHING (20). Assemble
the LAT BAR PLASTIC
HOLDER (21) onto the fop of the Arm Press Cap and directly behind the lip of the L-Shaped Welded Plate. Align
the bolt
holes in the Arm Press Cap and the Lat Bar Holder with the bolt holes in the L-Shaped Plate. Using 14" X 1" TAPER HEAD
SCREWS (63), Бой down through the top of the Lat Bar Holder, the Cap, and then the L-Shaped Plate. Secure with 1/4
NYLON
LOCK NUTS (61).
(0 Bolt the rear of the ARM PRESS CAP (19) assembly to the L-Shaped Welded Pilate on the MAIN UPRIGHT (10) with two
1/4* X 3/4" ROUND HEAD MACHINE SCREWS (62). Secure with 1/4" NYLON LOCK NUTS (61).
ГО Remove the ARM PRESS DECAL (93) from the backin sheet and position the Decal to the front of the cross member tube
on the ARM PRESS PIVOT FRAME (16).
g
Cap each end of the ARM PRESS ARMS (17) with 1 3/4" SQUARE PLASTIC INSERT CAPS (74).
C
Press the ARM PRESS ARMS (17) onto the 1" Welded Pivot Гибөз in the ARM PRESS PIVOT FRAME (16).
Advertisement
