Advertisement
СО Attach
the molded
PLASTIC
PEDAL TREAD (13) fo the top of
the STEPPER PEDALS (12) with
12" LONG
SELF
'TAPPING
PHILLIPS HEAD SCREWS (69).
C] Fit a 58" LD. Х 1 5/8" LONG
FLAIR END BUSHING (84) onto
the Cylinder Pivot Tube on the
STEPPER FRAME (11).
(0 Side а RESISTANCE CYLINDER
|
(14) over the Cylinder Pivot Tube
LUBRICATE
and secure in place with a 5/8"
SPRING RETAINER RING (79).
Again the teeth of the Retainer
Ring should be positioned
outward
and
use
the
5/8"
ROUND
PLASTIC
COVER CAP (73) as an
aid to help secure the Retainer
Ring
in place.
Tap this Cap and
Retainer Ring on using a hammer. :
[] To
the
bottom
end of the
RESISTANCE
CYLINDER
(14),
attach
the
CYLINDER
MOUNTING BRACKET-(15)
with .
a 516"
X 1 1/2"
HEX
HEAD
|
BOLT (44) and
a 5/16" NYLON
LOCK
NUT (41).
DO NOT OVER
TIGHTEN!
THIS
BRACKET
MUST BE FREE TO PIVOT.
ttre
[ Remove the STEPPER STATION
DECAL (94) from the backing
sheet and apply to the
STEPPER FRAME (11).
[О Remove
Ше
RESISTANCE
SCALE DECALS
(92) fom the
backing sheet and attach the
Decals to the STEPPER PEDALS
(12) along the side of the
FRAME (11) to farthest
away from
the Frame.
-
(3 вен the boit on the CYLINDER
MOUNTING BRACKET (15) into
one of the holes in the STEPPER
|
PEDAL (12) and secure with а
3/8" FLAT WASHER (50) and a
3/8" THREADED KNOB (98).
»
NOTE:
There
are
seven
hole
locations
in
the
STEPPER
PEDALS
(12).
The
Stepper
resistance
increases
аз
the
RESISTANCE
CYLINDER
(14) is
moved toward the end of the Pedal.
Advertisement
