Table of Contents
Advertisement
EN
Troubleshooting
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualified specialist if you
cannot solve the problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Cutting
result is
unsatisfactory
4. Product
suddenly
stops
5. Excessive
vibration or
noise
32
Possible cause
1.1. Battery pack is not
properly attached
1.2. Battery pack is
discharged
1.3. Battery pack is damaged
1.4. Other electrical defect to
the product
1.5. Safety key (16) not
properly inserted
2.1. Battery pack capacity
too low
2.2. Air vents are blocked
3.1. Cutting blade is dull /
damaged
3.2. Cutting material exceeds
capacity
3.3. Cutting height is incorrect
4.1. Battery pack is
discharged
4.2. Battery pack is too hot
4.3. Cutting device is blocked
5.1. Cutting device is dull/
damaged
5.2. Cutting material exceeds
capacity
5.3. Cutting height is incorrect
5.4. Bolts/nuts are loosen
TTT838LWM-Li by TITAN
Solution
1.1. Attach properly
1.2. Remove and charge
battery pack
1.3. Check by a specialist
electrician
1.4. Check by a specialist
electrician
1.5. Insert properly
2.1. Charge battery pack
2.2. Clean the air vents
3.1. Replace with a new one
3.2. Only cut materials
according to the product
capacity.
3.3. Adjust the cutting height
4.1. Remove and charge
battery pack
4.2. Remove battery pack
and let it cool down
4.3. Remove blockage
5.1. Replace with a new one
5.2. Only cut materials according
to the productcapacity
5.3. Adjust the cutting height
5.4. Tighten bolts/nuts
Advertisement
Table of Contents
