Remote Device Management (Rdm) - Elation PROTEUS RADIUS User Manual

R E M O T E D E V I C E M A N A G E M E N T ( R D M )
NOTE: In order for RDM to work properly, RDM enabled equipment must be used throughout
the entire system, including DMX data splitters and wireless systems.
Remote Device Management (RDM) is a protocol that sits on top of the DMX512 data standard
for lighting, allowing the DMX systems of the fixtures to be modified and monitored remotely.
This protocol is ideal for instances in which a unit is installed in a location that is not easily
accessible.
With RDM, the DMX512 system becomes bi-directional, allowing a compatible RDM enabled
controller to send out a signal to devices on the wire, as well as allowing the fixture to respond
(known as a GET command). The controller can then use its SET command to modify settings
that would typically have to be changed or viewed directly via the unit's display screen,
including the DMX Address, DMX Channel Mode, and Temperature Sensors.
FIXTURE RDM INFORMATION:
RDM Code
0x22A6
Please be aware that not all RDM devices support all RDM features, and therefore it is
important to check beforehand to ensure that the equipment that you are considering includes
all of the features that you require.
The following parameters are accessible in RDM on this device:
Device ID
Open
[0x0200] Sensor Definition
[0x0201] Sensor Value
[0x0080] Device Model Description
[0x0081] Manufacturer Label
[0x0082] Device Label
[0x00E0] DMX Personality
[0x00E1] DMX Personality Description
[0x0400] Device Hours
[0x0600] Pan Invert
[0x0601] Tilt Invert
[0x0500] Display Invert
Device Model ID
0x71E
40
Personality ID
Standard Mode (1)
Extended Mode (2)