Table of Contents
Advertisement
S A F E T Y G U I D E L I N E S
• DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow
approximately 15 minutes for the fixture to cool down before serving.
• DO NOT shake fixture, avoid brute force when installing and/or operating fixture.
• DO NOT operate fixture if the power cord is frayed, crimped damaged and/or if any of the
power cord connectors are damaged and do not insert into the fixture securely with ease.
• NEVER force a power cord connector into the fixture. If the power cord or any of its
connectors are damaged, replace it immediately with a new one of similar power rating.
• DO NOT block any air ventilation slots.
• All fan and air inlets must remain clean and never blocked.
• Allow approx. 10''(25cm) between fixture and other devices or a wall for proper cooling.
• When installing fixture in a suspended environment, always use mounting hardware that is
no less than M10x25mm, and always install fixture with an appropriately rated safety cable.
• Always disconnect fixture from main power source before performing any type of service
and/or cleaning procedure. Only handle the power cord by the plug end, never pull out the
plug by tugging the wire portion of the cord.
• During the initial operation of this fixture, a light smoke or smell may emit from the interior
of the fixture. This is a normal process and is caused by excess paint in the interior of the
casing burning off from the heat associated with the lamp and will decrease gradually over
time.
• Consistent operational breaks will ensure the fixture will function properly for many years.
• ONLY use the original packaging and materials to transport the fixture in for service.
8
Advertisement
Table of Contents
