Table of Contents
Advertisement
S YS T E M M E N U
FUNCTION - Auto Program
Define fixture mode (Primary or Alone) for running Auto Programs. Select desired internal
programs under "Select Program", set the number of steps under "Edit program", and edit
individual scenes under "Edit Scenes".
PERSONALITY - Status Settings - Address Via DMX
When ON, define the desired DMX address via an external controller.
NOTE: This process assumes the fixture DMX address is set to 001. If fixture DMX address
is not at 001, you must adjust the channel numbers accordingly in order for this feature
to work.
For example: if your fixture address is 010, then Channel 1 becomes Channel 10, Channel
2 becomes Channel 11, and Channel 3 becomes Channel 12.
1. Connect the fixture to the external controller and power ON.
2. Set the DMX value of Channel 1 on the controller to (7).
3. Set the DMX value of Channel 2 on the controller to (7) or (8). When set to (7), the DMX
address can be set between (1) and (255). When set to (8), the DMX address can be set
between (256) and (511).
4. Using Channel 3 on the controller set the desired DMX address of the fixture.
Example 1: If the desired DMX address is 57, set Channel 1 to a value of (7), set Channel 2
to a value of (7), and then set Channel 3 to a value of (57).
Example 2: If the desired DMX address is 420, set Channel 1 to a value of (7), set Channel 2
to a value of (8), and then set Channel 3 to a value of (164). (256+164=420)
5. After setting Channel 3 to the desired DMX address value, wait approximately 20 seconds for
the fixture to complete the address reset function.
PERSONALITY - Service Settings - Password (050)
NOTE: The Service Password MUST be entered in order to access the following menus:
Clear Err. Info
PERSONALITY - Display Setting - Key Lock
When ON, Control Panel buttons lock automatically after exiting main menu for 15 seconds. To
unlock, keep MODE/ESC button pressed for 3 seconds.
PERSONALITY - Dimmer Curve
Select dimming curve (Linear, Square, InverseSquare, S-Curve).
PERSONALITY - Reset Default (011)
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION!
NOTE:SAVED WHITE BALANCE IS ERASED AFTER A RESET IS PERFORMED!
This function restores all fixture settings to the factory default settings. The password is 011
and must be entered each time a reset is performed.
EFFECT ADJUST - Test Channel
Auto test each individual channel function independently from the DMX control board.
EFFECT ADJUST - Manual Control
Select and manually test and fine adjust each individual channel function Independently from
DMX control board. This function will center TILT motors and set dimmer to 100%. TILT functions
will still operate if the fixture needs to be positioned to a flat clear surface. With the individual
functions, you can focus the light on a flat surface (wall) and perform fine adjustments.
28
Advertisement
Table of Contents
