Table of Contents
Advertisement
Quick Links
We advise you to read this manual carefully, which contains all the instructions for maintaining the
appliance's aesthetic and functional qualities. For further information on the product: www.smeg.com
PRECAUTIONS
General safety instructions
Risk of personal injury
• During use the appliance and
its accessible parts become
very hot. Keep children well
away from the appliance.
• Protect your hands by wearing
oven gloves when moving food
inside the oven.
• Never try to put out a fire or
flames with water: Turn off the
appliance and smother the
flames with a fire blanket or
other appropriate cover.
• This appliance may only be
91477A460/B
3
3
7
8
8
8
8
8
8
8
9
9
9
10
10
10
11
11
11
12
12
12
used by children aged 8 years
and over, and by people of
reduced physical, sensory or
mental capacity, or lacking in
experience in the use of
electrical appliances, provided
that they are supervised or
have been given instructions on
the safe use of the appliance
and of the hazards associated
with it.
• Children must not play with the
appliance.
• Keep children under the age of
eight at a safe distance unless
they are constantly supervised.
13
13
14
16
17
18
19
19
19
19
19
21
21
22
23
23
23
26
27
30
30
PRECAUTIONS - 3
Advertisement
Table of Contents
Related Manuals for Smeg C6GMX2
Summary of Contents for Smeg C6GMX2
-
Page 1: Table Of Contents
Instructions for the installer Using the accessories We advise you to read this manual carefully, which contains all the instructions for maintaining the appliance’s aesthetic and functional qualities. For further information on the product: www.smeg.com PRECAUTIONS General safety instructions used by children aged 8 years... - Page 2 • Keep children under the age of • The appliance becomes very 8 away from the appliance hot during use. Take care never when it is in use. to touch the heating elements • Cleaning and maintenance inside the oven(s). must not be carried out by •...
- Page 3 APPLIANCE. support immediately to arrange • DO NOT USE AEROSOLS IN for it to be replaced in order to THE VICINITY OF THIS avoid possible hazards. APPLIANCE WHILST IT IS IN • WARNING: A gas cooking USE. appliance produces heat, •...
- Page 4 mechanical safety locks that cooking. prevent them from being • If you wish to use greaseproof removed must face downwards paper, place it so that it will not and towards the back of the interfere with the hot air oven. circulation inside the oven.
-
Page 5: Installation
lever the appliance into place • The settings for this appliance when fitting. are shown on the gas setting • Avoid exerting too much label. pressure on the door when • Have the gas connection open. performed by authorised • Take care that no objects are personnel. -
Page 6: Appliance Purpose
temperatures of at least 90°C. • use of non-original spare parts. • The tightening torque of the Identification plate screws of the terminal supply The identification plate bears the technical data, serial number and brand name of the wires must be 1.5 - 2 Nm. appliance. -
Page 7: To Save Energy
contained in a separate document conventions: accompanying the product instructions. These data are present in the "Product Warning/Caution information sheet" that can be downloaded from the website at the page dedicated to the product in question. Information/Advice To save energy •... -
Page 8: Description
DESCRIPTION General description 1 Upstand 6 Door 2 Hob 7 Fan 3 Control panel 8 Storage compartment 4 Oven light Frame shelf 5 Seal AUX = Auxiliary Burner SR = Semi-rapid Burner UR2 = Ultra Rapid Burner 10 - DESCRIPTION 91477A460/B... -
Page 9: Control Panel
Control panel 1 Hob burner knobs the appliance and which may continue for a brief period of time even after the appliance has For lighting and adjusting the hob burners. Press been turned off. and turn the knobs anti-clockwise to order to light the relative burners. -
Page 10: Use
Tray rack Trivet To be placed over the top of the tray; for Useful when using small cookware. cooking foods which may drip. Trivet Rack Useful when using a wok. Useful for supporting containers with food during cooking. Preliminary operations •... -
Page 11: Using The Hob
the food which is being cooked. Keep the knob pressed in longer. In case of an accidental switching off, a safety device will be tripped, cutting off the gas supply, even if the gas cock is open. Return the knob to and wait at least 60 seconds before lighting it again. -
Page 12: Digital Programmer
List of traditional cooking functions This function is particularly suitable for cooking on a single shelf with low Not all functions are available on some energy consumption. models. It is recommended for all types of food except those that may produce a large STATIC amount of moisture (e.g. - Page 13 1. Hold down the clock button for two To cancel the set programming press seconds. The dot between the hours and the and hold down the increase minutes flashes. the decrease keys at the same time 2. The time can be set via the increase key and then turn the oven off manually.
-
Page 14: Cooking Advice
12. Press the buttons at the same 2. Hold down the increase and decrease time to reset the set program. keys at the same time. 3. Then switch off the oven manually if cooking It is not possible to set a cooking time of is in progress. -
Page 15: Cooking Information Table
the dough. • Depending on the type of food and the increased quantity in the oven, cooking on • To check whether the dessert is cooked right two levels may take slightly longer through: At the end of the cooking time, put compared to cooking on a single shelf. -
Page 16: Cooking Information Table (Auxiliary Oven)
Weight Temp. Time Food Function Shelf (Kg) (°C) (minutes) Salmon trout TURBO/CIRCULAIRE 150 - 160 35 - 40 Monkfish TURBO/CIRCULAIRE 60 - 65 Turbot TURBO/CIRCULAIRE 45 - 50 Pizza TURBO/CIRCULAIRE 8 - 9 Bread CIRCULAIRE 190 - 200 25 - 30 Focaccia TURBO/CIRCULAIRE 180 - 190... -
Page 17: Cleaning And Maintenance
CLEANING AND MAINTENANCE Cleaning the appliance respective burner caps. Igniters and thermocouples See General safety instructions. For correct operation the igniters and thermocouples must always be perfectly clean. Check them frequently and clean them with a Cleaning the surfaces damp cloth if necessary. Remove any dry To keep the surfaces in good condition, they residues with a wooden toothpick or a needle. - Page 18 2. Grasp the door on both sides with both 4. Then remove the inner glass pane from the hands, lift it forming an angle of around 30° front profile. and remove it. 5. Remove the intermediate glass unit by lifting it upwards.
-
Page 19: Cleaning The Oven Cavity
8. Reinsert the intermediate glass unit and Removing racks/trays support frames reposition the inner glass. Removing the rack/tray support frames enables the sides to be cleaned more easily. To remove the rack/tray support frames: • Pull the frame towards the inside of the oven cavity to unhook it from its groove A, then slide it out of the seats B at the back. -
Page 20: Extraordinary Maintenance
• During the assisted cleaning cycle, wash the Replacing the internal light bulb self-cleaning panels (where fitted), which Power voltage were previously removed, separately in Danger of electrocution warm water and a small amount of detergent. • Unplug the appliance. Vapor Clean cycle setting •... -
Page 21: Installation
6. Refit the cover. Ensure the moulded part of 7. Press the cover completely down so that it the glass (A) is facing the door. attaches perfectly to the bulb support. INSTALLATION The appliance must be installed by a qualified technician and according to the regulations in force. - Page 22 • The hose is not under traction or tension and comply with the applicable standard. has no kinks or twists • The hose is not in contact with sharp objects or sharp corners • If the hose is not perfectly airtight and leaks gas, do not try to repair it;...
- Page 23 comply with the applicable standard. Extraction of the combustion products The combustion products may be extracted by means of hoods connected to a natural draught chimney whose efficiency is certain or via forced extraction. An efficient extraction system requires precision planning by a specialist qualified in this area and must comply with the positions and clearances indicated by the applicable standards.
-
Page 24: Gas Types And Countries
Light the burner and turn it to the minimum Replacing nozzles position. Extract the gas cock knob and turn the adjustment screw next to the gas cock spindle (depending on the model) until the correct minimum flame is achieved. Refit the knob and verify that the burner flame is stable. -
Page 25: Burner And Nozzle Characteristics Tables
Gas types 5 LPG G30/31 28-30/37 mbar G30/31 • • • • • • 30/30 mbar G30/31 • • • 6 LPG G30/31 37 mbar G30/31 • 7 Town Gas G110 8 mbar • • G110 It is possible to identify the available gas types based on the country the appliance is to be installed in. - Page 26 7 Town gas G110 – 8 mbar Rated heating capacity (kW) Nozzle diameter (1/100 mm) Pre-chamber (printed on nozzle) (/8) (/2) 0190 Reduced flow rate (W) 1200 The nozzles not provided are available at Authorised Service Centres. Appliance overall dimensions Appliance dimensions 600 mm 600 mm...
- Page 27 Assembling the upstand 3. Assemble the fastening bracket. The upstand must always be positioned and 4. Align the base of the hook on the fastening secured correctly on the appliance. bracket with the base of the slot on the wall 1.
-
Page 28: Electrical Connection
7. Move the bracket onto the wall and mark • 220-240 V 1N~ the position of the holes to be drilled in the wall. fig. 1 The values indicated refer to the cross- section of the internal conductor. The aforementioned power cables are sized taking into account the 8. - Page 29 Centre. • Once the appliance has been installed, please explain to the user how to use it correctly. 91477A460/B INSTALLATION - 31...
Need help?
Do you have a question about the C6GMX2 and is the answer not in the manual?
Questions and answers