Safety Information - Smeg HOBD682D2 User Manual

EN

1. SAFETY INFORMATION

For your own safety and
correct operation of the
appliance, please read
this manual carefully be-
fore installation and oper-
ation. Always keep these
instructions together with
the appliance, even if it is
sold or transferred to third
parties. It is important that
users are familiar with all
the appliance's operating
and safety characteristics.
These hobs have induc-
tion systems that comply
with the requirements of
EMC standards and with
the EMF directive, and
they should not interfere
with
devices.
wearers and those using
other electronic implants
must consult their doctor
or the manufacturer of the
implanted device to as-
sess whether or not it is
sufficiently resistant to in-
terference.
Electrical
must be performed by a
trained technician. Before
making the electrical con-
nection, please read the
section on ELECTRICAL
CONNECTION.
For appliances with a power
supply cable, the terminals or
section of wire between the
cable anchor point and the ter-
minals must be laid out so that
they allow the live wire to be ex-
18
other electronic
Pacemaker
connections
tracted before the earth wire if it
comes loose.
• The manufacturer cannot be
held responsible for any dam-
age resulting from incorrect or
inadequate installation.
• Check that the mains power
supply corresponds to the
one indicated on the rating
plate affixed to the inside of
the product.
• The cut-out devices must be
installed in the fixed system
according to the wiring sys-
tem regulations.
• For Class I appliances, check
that the domestic power sup-
ply has a suitable earthing
connection.
• Connect the suction hood to
the flue using a suitable pipe.
Refer to the purchasable ac-
cessories indicated in the in-
stallation manual (for circular
pipes: minimum diameter 120
mm). The length of the dis-
charge piping must be as
short as possible.
• Connect the product to the
mains using an omnipolar
switch.
• The air venting regulations
must be complied with.
• Never connect the suction ap-
pliance to ducts carrying com-
bustion fumes (heaters, fire-
places, etc.).
• If the suction hood is used
alongside non-electrical ap-
pliances (e.g. appliances with
gas burners), it is necessary
to guarantee a sufficient level
of ventilation in the room, to