KÜBLER SPORT D5172 Assembly Instruction

Small training goal robust welded 1.80 x 1.20m

Download this manual

Assembly instruction Small

ROBUST

training goal; Completely

welded 1.80 x 1.20m

Cat.-No.: 1163836 / 1163810

D5172, D5173

Thanks for choosing Sport-Thieme equipment. In order to enjoy this product please note

the following instructions for safety, use and maintenance before assembly.

As this goal is completely welded only the net needs to be mounted at the goal (see point 2).

1. Scope of delivery:

Please check the following content before assembly.

Piece

Description

Completely welded goal

Net with fixing cord

Accessories:

2. Assembly of the net:

Make sure that the groove of the goal is clean and all packing material or other

material is removed so that the assembly is possible without any problems.

Now fix and adjust the net rope in the groove. Then stick net holders with its clips into

the groove and fix them with a 90° rotation. Fixing is either possible manually, with

the key for hexagon socket screws or with a pliers (see bottom pictures). Distribute

net holders equally (same distances).

Kübler Sport

45 x net holder

2 x plastic stopper Ø 28mm

1 x hexagon screwdriver SW5

1 x assembly instruction

Need help?

Do you have a question about the D5172 and is the answer not in the manual?

Page 1 ROBUST training goal; Completely welded 1.80 x 1.20m Cat.-No.: 1163836 / 1163810 D5172, D5173 Kübler Sport Thanks for choosing Sport-Thieme equipment. In order to enjoy this product please note the following instructions for safety, use and maintenance before assembly. As this goal is completely welded only the net needs to be mounted at the goal (see point 2).
Page 2 We recommend the following distribution of net holders: crossbar : 10 pieces upright : 7 pieces each ground bar : 5 pieces each ground tube : 10 pieces Use all the other included net holders for corners and other connections. Pull the cord through each net meshes and fix it on both net hoops, if necessary lead it through the bore in the net hoop.
Page 3 5. Inspection and maintenance: a) Visual inspections should routinely be realized before each use. b) Functional inspections should take place at least every six months or according to manufacturer’s instructions/national regulations/standard specifications. c) A general inspection should be realized at least once a year or according to manufacturer’s instructions/national regulations/standard specifications.

D5173