Table of Contents
Advertisement
INSTALLATION DETAILS CONT.
• Cold air will blow from the air outlet during operation,
avoid installing in locations where the surroundings may
be impacted.
• Install the heat pump unit outdoors in a well-ventilated area
where accumulated snow etc. will not be a hindrance.
• Keep the unit at least 3 m away from TV antennas or wireless
devices, and 2 m away from associated main body and cables.
2
6
• Do not install in areas with high levels of sulphide gas
components and/or locations that have a lot of oil such as
machine oil etc.
(Avoid installing in locations where strong wind blows
continuously. The fan rotates on high speed.)
• Do not install the heat pump unit near the supply/exhaust
pipe of a combustion device.
Height difference with the hot water storage tank
• Confirm the piping conditions for when there is a height
difference then decide on the installation location.
Installation space required for the heat pump unit
• Ensure to open at least 3 directions out of the front, back, left,
and right for the air outlet side to secure a ventilation path.
• If only 2 directions can be kept open, the boiling capacity
may decrease.
• If the installation space is small, frost or condensation water
forms on the entire surface of the heat pump unit, which
causes it to get wet.
• If there are any obstacles such as walls in the surroundings,
follow the instructions on the figure 2.
14
Reclaim Energy |
Quick Start/Install Manual – v1.0
2.3.2
MOUNTING
Note: Reclaim Energy ASHP MUST be installed on the
ground with mounting frames that is a default supplied
component OR on the wall with brackets. Note: A plumber
needs to have access to the underneath and to the side of
the unit for maintenance.
Figure 4: Ground mounting frames.
Figure 5: Wall mounting brackets
Advertisement
Table of Contents
