Table of Contents
Advertisement
THE FOLLOWING INSTRUCTIONS ARE REQUIRED TO BE
MET TO INSTALL THE HEAT PUMP UNIT.
1 Install the stand (Resin stand)
• Install a stand with a height of 100 mm or more on a
horizontal surface outdoors. Do not place the heat
pump unit directly on the ground.
(Failure to do so may result in poor drainage of drain
water, resulting in equipment damage)
• Use a stand that has an allowable loading mass of 50
kg (allowable load of 490 N or more) or more.
2 Fix the stand's legs with bolts (4 places)
RECLAIMENERGY.COM.AU
3 Check the level with a spirit level
• Avoid installing in places where water accumulates
when it rains or snows, places where snow drifts or
falls, and/or where sewage gas flows backwards.
WHEN HIGH STANDS ARE NECESSARY
For snowy areas, use a high stand to keep the unit from
getting buried in the accumulated snow.
If water cannot be drained due to freezing,
DO NOT USE A DRAIN ELBOW.
Drain Port
When using a high stand, select a stand that can
withstand the mass of the heat pump unit, and take
Drainage ditch
appropriate measures to secure and prevent the unit
from falling, such as fixing it using anchor bolts.
High Stand
• Since drain water flows
directly from the drain port,
water may flow around the
installed stand and freeze.
When installing on the
foundation of a house such
as beams etc., lead the
drain water to the drain
using a suitable method so
that it does not freeze.
Quick Start/Install Manual – v1.0
Drain Port
Drainage ditch
Drain Port
High Stand
Drainage ditch
High Stand
| Reclaim Energy
6 2
15
Advertisement
Table of Contents
