Table of Contents
Advertisement
Master Reset
A Master Reset is part of the final test at the factory, which will
Note !
reset the memories to factory settings. Unless you need to clear
all stored values during the installation setup procedure, you
should not perform a Master Reset.
In the event a Master Reset has been made, refer to chapter 4.2.
Final sea trial
After having completed all settings in the Installation Menu, take
the boat out and perform a final sea trial in open waters at a safe
distance from other traffic. .
− Steer the boat on all cardinal headings in AUTO mode.
− Start with low and medium speeds to get familiar with the
− Try the effect of LO and HI parameter settings.
− If the hardware for automatic HI/LO parameter selection is
− Try the Dodge and U-turn function.
− If a Non-Follow Up lever (or handheld remote) is connected,
20221560A
response from the AP16.
connected and configured, verify that the HI/LO transition is
occurring, and the HI/LO parameters are changing after the
transition speed is crossed (by more than 1 Knot higher or
lower speed).
test change of modes and verify port and starboard steering
commands of the lever.
Configuration and setup
The Master Reset needs a
double
confirmation
prevent an accidental reset. To
perform a Master Reset, press
the STBD 10 button and
observe the display; then
press the PORT 10 button.
The display will then read:
"Master Reset confirmed".
Unless you have made a
Master
Reset,
Installation Menu by pressing
STBY to return to normal
AP16 operation.
to
exit
the
109
Advertisement
Table of Contents
