Table of Contents
Advertisement
76
On the
road
compartment is addit ionally heated by
the sun's rays.
(D
Note
Do not stop the engine immed iate ly after
hard or extended driving. Keep the engine
running for approximately two minutes to
prevent excessive heat build -up.
Driver message in the instrument
cluster display
Turn off ignition before leaving car
This message appears and a warning tone
sounds if you open the dr iver's door when the
ignit ion is switched on .
Press brake pedal to start engine
This message appears if you press the
I
START ENGINE STOP !
button to start the en-
gine and do not depress the brake pedal. The
engine can on ly be started if the brake pedal
is depressed.
Ill
Is key in the vehicle?
If the ind icato r light turns on and the mes-
sage appears, the remote control key was re-
moved from the vehicle while the engine was
running . If the ignition key is not in the vehi-
cle you will not be able to switch on the igni-
tion or restart the engine after it has been
switched off. You w ill also not be able to lock
the vehicle from the outside .
Shift to P, otherwise vehicle can roll away.
Doors do not lock if lever is not in P.
This message appears for saf ety reasons
along with an audib le warning tone if the P
selector lever position is not engaged when
stopping the engine with the
I
STAR T E NGIN E STOP !
but t on . Select the P se-
lector lever posit ion . Otherwise the vehicle
could roll and it cannot be locked.
II
Key is not recognized. Hold back of key
against marked area. See owner's manual.
If the indicator light turns on and this mes-
sage appears, there is a malfunction
¢ page 76.
Turn off ignition before leaving car. Battery
is discharging
This message appears if the driver's door is
opened wh ile the ignition is switched on. Al-
ways switch off the ignit ion if you are leaving
the vehicle . See also ¢
page 80 .
Shift to P and turn off ignition before leav-
ing car, otherwise vehicle can roll away
This message appears if the driver's door is
opened wh ile the ignition is switched on and
the select or lever is not in the P position. Shift
the selector lever into the P position and
swit ch off the ignition when you exit the vehi-
cle. Otherwise the vehicle could roll . See also
¢ page 80.
Starting the engine if there is a
malfunction
It may not be possible to start the engine un-
der cert ain circumstances, for example if the
batt ery in the vehicle key is drained, if inter-
ference hos affected the key or if there is a
system malfunction .
Fig. 78
Cent er console/master
key:
star tin g t he eng ine
if the re is a malfunct ion
Requirement: The message Key not recog-
nized. Hold back of key against marked area.
See owner's manual. must appear and the in-
dicator light
II
must switch on .
.,. Hold the master key vertically in the loca-
tion indicated
f>l)
¢
fig. 78 .
.,. Press the brake pedal ¢
A
in Starting the
engine on page 75 .
Advertisement
Table of Contents
