Panasonic CT-36SL13G Service Manual page 40

http://tsn.pstc.panasonic.com/viewing/NA/CT-36SL13G/SVC/s1200000000x.html
Apply a green pattern with a horizontal line, adjust the Deflection Yoke so that has no tilt, then secure it.
Adjust center line of the pattern with the mechanical center of the CRT, this center is determined by two
marks at the side edges of the screen. To adjust the line, once the vertical raster shift tabs are place at 3
o'clock to reduce itsmagnetic field effect open the tabs the same angle from the center, until the center
line of the pattern becomes a straight line, centered with the marks of the CRT.
IMPORTANT NOTICE
Rings come along with deflection yoke in one piece.
INITIAL CENTER STATIC CONVERGENCE
Connect a dot/cross hatch generator to the receiver and tune in a signal. Observe misconvergence at
center of the screen only.
Adjust the R&B pole magnets; by separating tabs and rotating to converge blue with red.
Adjust the R&B and R&B&G pole magnets: by separating tabs and rotating to converge blue and red
(magenta) with green.
NOTE
Precise convergence at this point is not important.
http://tsn.pstc.panasonic.com/viewing/NA/CT-36SL13G/SVC/s1200000000x.html (3 of 5)05.12.2008 0:01:52
Vertical raster shift adjustment