http://tsn.pstc.panasonic.com/viewing/NA/CT-36SL13G/SVC/s0200000000x.html
3. Remove the solder from all the pads of the Flat IC by using a de solder braid
4. Position the new Flat IC in place (apply the pins of the Flat IC to the soldering pads where the
pins need to be soldered). Properly determine the positions of the soldering pads and pins by
correctly aligning the polarity symbol
5. Solder all pins to the soldering pads using a fine tipped soldering iron
6. Check with a magnifier for solder bridge between the pins or for dry joint between pins and
soldering pads. To remove a solder bridge, use a de solder braid as shown in the figure below
http://tsn.pstc.panasonic.com/viewing/NA/CT-36SL13G/SVC/s0200000000x.html (3 of 4)05.12.2008 0:00:25