Advertisement
Drainage Guide
During dehumidifying mode, remove the upper drain plug
from the back of the unit, install the drain connector (5/8"
universal female mender) with 3/4" hose (not inlcuded).
For the models without drain connector, just attach the
drain hose to the hole. Place the open end of the hose
directly over the drain area in your basement floor. During
heat pump mode(only on some models), remove the lower
drain plug from the back of the unit, install the drain
connector.
NOTICE
Make sure the hose is secure so there are no leaks. Direct
the hose toward the drain, making sure that there are no
kinks that will stop the water flowing. Place the end of
the hose into the drain and make sure the end of the
hose is down to let the water flow smoothly. When the
continuous drain hose is not used, ensure that the
corresponding drain plug and knob are installed firmly to
prevent leakage.
During heat pump mode(only on some models), remove
the lower drain plug from the back of the unit, install the
drain connector (5/8" universal female mender) with 3/4"
hose (not inlcuded).
Carefully move the unit to a drain location, and let the
water drain away.
NOTICE
Make sure the drain hose is lower than the bottom tray
drain outlet.
When the water level of the bottom tray reaches a
predetermined level, the unit beeps 8 times, the digital
display area shows "P1". At this time the air conditioning/
dehumidification process will immediately stop. However,
the fan motor will continue to operate (this is normal).
Carefully move the unit to a drain location, remove
the bottom drain plug and let the water drain away.
Reinstall the bottom drain plug and restart the
machine until the "P1" symbol disappears. If the
error repeats, call for service.
NOTICE
Be sure to reinstall the bottom drain plug firmly
to prevent leakage before using the unit.
Remove the
upper drain
plug
Continuous
drain hose
Remove the
lower drain
plug
Continuous
drain hose
20
Advertisement
