Multi Zone - Bauknecht OBBC Ecosilent 8650 Daily Reference Manual

OPTIONS AND FUNCTIONS
OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL).
If an option is not compatible with the selected program see PROGRAMS TABLE, the corresponding LED flashes rapidly 3 times
and beeps will sound. The option will not be enabled.
MULTIZONE
If there are not many dishes to be washed, a half loading may
be used in order to save water, electricity and detergent.
Select the program and then press the MULTIZONE button:
the indicator over the button lights up and the symbol of the
chosen rack will appear on the display. By default the appliance
washes dishes in all racks.
To wash only the specific rack, press this button repeatedly:
shown on the display (only lower rack)
shown on the display (only upper rack)
shown on the display (only cutlery rack)
shown on the display (option is OFF and the appliance will
wash dishes in all racks).
Remember to load the upper or lower rack only, and to
reduce the amount of detergent accordingly.
If upper rack is removed, please apply detergent directly
to tub instead of detergent dispenser.
KEYLOCK
A long press (for 3 seconds) of MULTIZONE button, will activate
the KEYLOCK function. The KEYLOCK function will block the
control panel except the ON/OFF button.
To deactivate the KEYLOCK, long press again.
WATER TAP CLOSED – Alarm
Flashes when there is no inlet water or water tap is closed
SANI RINSE
This option can be used to sanitize washed dishes. It will in-
crease final rinse temperature and add antibacterial wash to
the selected program. Select the washing program, press the
SANI RINSE button; the indicator light will light up. To deselect
the option, press the sa me button again. Ideal to clean crockery
and feeding bottles. The dishwasher door must be kept shut
for the entire duration of the program in order to guarantee
reduction of germs. If the door is opened the indicator lamp
starts flashing.
WARNING: the crockery and plates could be extremely hot
at the end of the cycle.
TABLET
This setting allows you to optimize the performance of the
program according to the type of detergent used.
A long press (for 3 seconds) of the SANI RINSE button, will ac-
tivate the function (the corresponding symbol will light up)
if you use combined detergents in tablet form (rinse aid, salt
and detergent in 1 dose).
If you use powder or liquid detergent, this option should
be off.
4
DELAY
The start of the program may be delayed for a period of
time between 0:30 and 24 hours.
1. Select the program and any desired options. Press the DELAY
button (repeatedly) to delay the start of the program. Adjust-
able from 0:30 to 24 hours. With each press of the button, the
delay start increases by: 0:30 if selection below 4 hours, 1:00
if selection is below 12 hours, 4 hours if selection is above
12 hours. If 24 hours reached, and the button is pressed, the
delayed start is deactivated.
2. Press the START/PAUSE button: the timer will begin counting
down;
3. Once this time has elapsed, the indicator light switches off and
the program begins automatically.
If at the time of the countdown the START/PAUSE button is
pressed again the DELAY option is cancelled and the selected
program starts automatically.
The Delay function cannot be set once a wash cycle has
been started.
DRAIN OUT
To stop and cancel the active cycle, the Drain Out function can
be used.
A long press of START/PAUSE button, will activate the DRAIN
OUT function. The active program will be stopped and the
water in the dishwasher will be drained out.
.
ActiveDry
ActiveDry is a convection drying system which automatically opens
the door during/after drying phase to ensure exceptional drying per-
formance every day. Door opens at the temperature that is safe to your
kitchen furniture, thus door will not be opened when the option of SANI
RINSE is on.
As additional steam protection, special designed protection foil is added
together with the dishwasher (depending on the model type - can be
the need to buy it). To see how to mount protection foil please refer to
(INSTALLATION GUIDE).
ActiveDry functionality could be disabled by the user as follows:
• To DISABLE: Switch On, then switch Off. Keep the P button pressed for
5 sec., at the end of 5 sec the dishwasher plays a short beep. Switch
On the machine, the display shows „oOF".
• To ENABLE: Switch On, then switch Off the machine. Keep the P but-
ton pressed for 5 sec., at the end of 5 sec the dishwasher plays a short
beep. Switch On the machine, the display shows „oOn".